Quality of Service Guide Network QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 199
4.4.2.2 Operational Commands
copy
Syntax copy network src-pol dst-pol [overwrite]
Context config>qos
Description This command copies existing QoS policy entries for a QoS policy ID to another QoS policy
ID.
The copy command is used to create new policies using existing policies and also allows bulk
modifications to an existing policy with the use of the overwrite keyword.
Parameters src-pol dst-pol — indicates that the source and destination policies are network policy
IDs. Specify the source policy that the copy command will copy and specify the
destination policy to which the command will duplicate the policy to a new or different
policy ID.
Values 1 to 65535
overwrite — specifies that the existing destination policy is to be replaced. Everything in
the existing destination policy will be overwritten with the contents of the source
policy. If overwrite is not specified, an error will occur if the destination policy ID
exists.
ALU>config>qos# copy network 1 427
MINOR: CLI Destination "427" exists use {overwrite}.
ALU>config>qos# copy network 1 427 overwrite
To Next Page
Loading...
