Quality of Service Guide ATM QoS Traffic Descriptor Profiles
Edition: 01 3HE 11014 AAAC TQZZA 401
8.4.2.2 Operational Commands
copy
Syntax copy atm-td-profile src-prof dst-prof [overwrite]
Context config>qos
Description This command copies the source ATM traffic descriptor profile into the destination ATM
profile. If the destination profile was already defined, the keyword overwrite must be
appended for the copy to complete.
The copy command is a configuration level maintenance tool used to create new profiles
using existing profiles. It also allows bulk modifications to an existing profile with the use of
the overwrite keyword.
Parameters src-prof dst-prof — indicates that the source profile ID and the destination profile ID are
atm-td-profile IDs. Specify the source ID that the copy command will copy and
specify the destination ID to which the command will duplicate the profile.
Values 1 to 1000
overwrite — specifies that the existing destination profile is to be replaced. Everything in
the existing destination profile will be overwritten with the contents of the source
profile. If overwrite is not specified, an error will occur if the destination profile ID
exists.
ALU-48>config>qos# copy atm-td-profile 2 10
MINOR: CLI destination (10) exists use {overwrite}.
ALU-48>config>qos# copy atm-td-profile 2 10 overwrite
ALU-48>config>qos#
To Next Page
Loading...
