Quality of Service Guide ATM QoS Traffic Descriptor Profiles
Edition: 01 3HE 11014 AAAC TQZZA 385
Example: *A:ALU-1# configure qos
config>qos# atm-td-profile 3 create
config>qos>atm-td-profile$ description "ATM TD profile3"
config>qos>atm-td-profile$ service-category rt-vbr
config>qos>atm-td-profile$ descriptor-type P0_1andS0_1
config>qos>atm-td-profile$ policing
config>qos>atm-td-profile$ shaping
config>qos>atm-td-profile$ traffic sir 500 pir 500 mbs
500 cdvt 500
config>qos>atm-td-profile$ exit
config>qos# exit
The following output displays the profile configuration for ATM TD profile 3:
*A:ALU-1>config>qos# info
#--------------------------------------------------
echo "QoS Policy Configuration"
#--------------------------------------------------
...
atm-td-profile 3 create
description "ATM TD profile3"
service-category rt-vbr
traffic sir 500 pir 500 mbs 500 cdvt 500
policing
exit
...
*A:ALU-1
8.2.2 Applying ATM Traffic Descriptor Profile Policies
ATM QoS traffic descriptor profiles are applied to ATM VLL (Apipe) SAPs. ATM QoS
traffic descriptor profiles can also be applied on egress to ATM VCC SAPs that are
members of a SAP aggregation group. You cannot apply ATM QoS traffic descriptor
profiles on ingress to a SAP in a SAP aggregation group; the profile is set to the
default (1).
8.2.2.1 ATM VLL (Apipe) SAPs
Use the following CLI syntax to apply ATM QoS traffic descriptor profile policies to
Apipe SAPs on ingress and egress.
CLI Syntax: config>service>apipe>sap# atm
egress
traffic-desc traffic-desc-profile-id
ingress
To Next Page
Loading...
