QoS Fabric Profiles
408
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
9.1 Basic Configuration
This section contains the following topic related to creating and applying QoS fabric
policies:
• Creating a QoS Fabric Profile
• Applying a QoS Fabric Profile
• Default Fabric Profile Values
A QoS fabric profile must conform to the following rules.
• Each profile must be associated with a unique policy ID.
• Either aggregate mode or per-destination mode must be assigned.
9.1.1 Creating a QoS Fabric Profile
Creating a QoS fabric profile other than the default policy (“default”) is optional. To
create a QoS fabric profile, perform the following:
• assign a policy ID (policy number) — the system does not dynamically assign an
ID
• include an optional description of the policy
• assign the mode, either aggregate or per-destination. If no mode is assigned,
the default aggregate mode is used.
• configure the to-fabric shaper rate
• (optional) for hierarchical QoS (H-QoS), configure the unshaped SAP CIR rate
(see Configuring per-SAP Aggregate Shapers and an Unshaped SAP
Aggregate Shaper (H-QoS))
Use the following CLI syntax to configure a QoS fabric profile:
CLI Syntax: config>qos#
fabric-profile policy-id aggregate-mode create
aggregate-rate aggregate-rate [unshaped-sap-
cir cir-rate]
description description-string
fabric-profile policy-id destination-mode create
description description-string
dest-mda <slot/mda | multipoint>
rate mda-rate
To Next Page
Loading...
