Service Egress and Ingress QoS Policies
278
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
The following Epipe service output shows that the SAP service egress and ingress
reverted to policy-id “1” when the non-default policies were removed from the
configuration.
ALU-1>config>service>epipe# info detail
----------------------------------------------
description "Distributed Epipe service to west coast"
service-mtu 1514
sap 1/1/10:0 create
no description
no multi-service-site
ingress
qos 1
exit
egress
qos 1
exit
no collect-stats
no accounting-policy
no shutdown
exit
spoke-sdp 2:6 vc-type ether create
no shutdown
exit
no shutdown
----------------------------------------------
ALU-1>config>service>epipe#
6.3.1.2 Removing a Policy from the QoS Configuration
Use the following syntax to remove a QoS policy:
CLI Syntax: config>qos# no sap-ingress policy-id
To Next Page
Loading...
