Nokia 7705 - 5.1.5 Label Exchange

Quality of Service Guide Slope QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 375
7.4.2.3 Show Commands
slope-policy
Syntax slope-policy [slope-policy-name] [detail]
Context show>qos
Description This command displays slope policy information.
Parameters slope-policy-name — the name of the slope policy
detail — displays detailed information about the slope policy
Output The following output is an example of slope policy information, and Table 51 describes the
fields.
Output Example
*A:ALU-1# show qos slope-policy SlopePolicy1 detail
===============================================================================
QoS Slope Policy
===============================================================================
Policy : SlopePolicy1
Description : Test1
Time Avg : 3
-------------------------------------------------------------------------------
High Slope Parameters
-------------------------------------------------------------------------------
Start Avg : 90 Admin State : Disabled
Max Avg : 90 Max Prob. : 60
-------------------------------------------------------------------------------
Low Slope Parameters
-------------------------------------------------------------------------------
Start Avg : 75 Admin State : Disabled
Max Avg : 75 Max Prob. : 40
-------------------------------------------------------------------------------
Associations
-------------------------------------------------------------------------------
Object Type Object Id Queue
-------------------------------------------------------------------------------
sap-ingress 1 1
sap-ingress 8 1
sap-ingress 8 2
sap-egress 1 1
network-queue default 1
network-queue default 2
network-queue default 3
network-queue default 4
Note: The following command outputs are examples only; actual displays may differ
depending on supported functionality and user configuration.