Nokia 7705 - 6.2.1.2 Creating a Service Ingress QoS Policy

Service Egress and Ingress QoS Policies
264
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
The following output displays the queue configuration for service egress policy 500:
ALU-1>config>qos# info
--------------------------------------------------
#--------------------------------------------------
echo "QoS Policy Configuration"
#--------------------------------------------------
....
sap-egress 500 create
description "Egress Policy 500"
queue 1 create
exit
queue 7 best-effort create
rate max cir max
cbs 10
mbs 10
high-prio-only 10
exit
fc be create
exit
fc ef create
dscp in-profile cp2 out-profile cp3
exit
6.2.1.2 Creating a Service Ingress QoS Policy
After the policy is created, the policy’s behavior can be defined. In addition, the
behavior of policy’s FC and queue can be changed from their default settings:
• Creating a Service Ingress Forwarding Class
• Creating a Service Ingress QoS Queue
To create an service ingress policy, define the following:
• a policy ID value — the system does not dynamically assign a value. Optionally,
a policy name can be configured after the policy has been created.
• a description — provides a brief overview of policy features
• a default forwarding class for the policy — all packets received on an ingress
SAP using this ingress QoS policy will be classified to the default forwarding
class
• a default priority for all packets received on an ingress SAP using this policy
• the dot1p parameters — this configuration creates a mapping between the dot1p
bits of the ingress traffic and the forwarding class
• the DSCP parameters — this configuration creates a mapping between the
DSCP of the ingress traffic and the forwarding class