Quality of Service Guide Network Queue QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 221
The following output displays the configuration for a network queue policy applied to
a ring port.
*A:7705custDoc:Sar18>config>port>ethernet>network# info detail
----------------------------------------------
queue-policy "NQpolicy5"
scheduler-mode 16-priority
----------------------------------------------
5.2.4 Configuring Per-VLAN Network Egress Shapers
Per-VLAN network egress shapers can be configured for network interfaces. Refer
to the 7705 SAR Router Configuration Guide for command descriptions.
The queue-policy command is used to enable and disable the network egress per-
VLAN shapers on a per-interface basis. If the no queue-policy command is used,
the VLAN (that is, the interface) defaults to unshaped mode. The agg-rate-limit
command cannot be accessed unless a network queue policy is assigned to the
interface.
Use the following CLI syntax to configure a per-VLAN network egress shaper on a
network interface:
CLI Syntax: config>router>interface#
egress
queue-policy name
agg-rate-limit agg-rate [cir cir-rate]
5.2.5 Configuring a CIR for Network Egress Unshaped
VLANs
To provide arbitration between the bulk (aggregate) of unshaped VLANs and the
shaped VLANs, assign a rate to the unshaped VLANs. Refer to the 7705 SAR
Interface Configuration Guide for command descriptions.
Use the following CLI syntax to configure a CIR for the bulk of network egress
unshaped VLANs:
CLI Syntax: config>port>ethernet#
network
egress
unshaped-if-cir cir-rate
To Next Page
Loading...
