Nokia 7705 - 5.2.2 Creating a Network Queue QoS Policy

Network Queue QoS Policies
216
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
5.2.2 Creating a Network Queue QoS Policy
By default, all network queue policies are created with queue 1 and (multipoint)
queue 9 applied to the policy. Similarly, when an FC is created within a network
queue policy, the default unicast queue 1 and multicast queue 9 are assigned to the
FC. The multipoint keyword applies to queues 9 to 16.
Use the following CLI syntax to create a network queue QoS policy.
CLI Syntax: config>qos
network-queue policy-name
description description-string
fc fc-name
multicast-queue queue-id
queue queue-id
queue queue-id [multipoint] [queue-type]
adaptation-rule [pir adaptation-rule]
[cir adaptation-rule]
cbs percent
high-prio-only percent
mbs percent
rate percent[cir percent]
slope-policy name
The following example creates a unicast and a multipoint network queue policy.
Example: ALU-1# config>qos# network-queue NQ1 create
config>qos>network-queue$ description "NetQueue1"
config>qos>network-queue$ fc be create
config>qos>network-queue>fc$ exit
config>qos>network-queue# queue 10 multipoint create
config>qos>network-queue>queue# exit
config>qos>network-queue$ fc h1 create
config>qos>network-queue>fc$ multicast-queue 10
config>qos>network-queue>fc$ exit
config>qos>network-queue# exit
config>qos# exit
ALU-1#
The following output displays the configuration for NQ1.
ALU-1>config>qos# network-queue NQ1
ALU-1>config>qos>network-queue# info detail
----------------------------------------------
description "NetQueue1"
queue 1 auto-expedite create
no avg-frame-overhead
rate 100 cir 0
adaptation-rule pir closest cir closest