Nokia 7705 - Page 267

Quality of Service Guide Service Egress and Ingress QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 267
6.2.1.2.2 Creating a Service Ingress QoS Queue
To create service ingress queue parameters, define the following:
• a new queue ID value — the system does not dynamically assign a value
• the queue parameters — ingress queues support explicit and auto-expedite
hardware queue scheduling
Use the following CLI syntax to configure SAP ingress QoS queue parameters:
CLI Syntax: config>qos# sap-ingress policy-id
queue queue-id [queue-type] [queue-mode]
adaptation-rule [pir adaptation-rule] [cir
adaptation-rule]
cbs size-in-kbytes
high-prio-only percent
mbs size [bytes | kilobytes]
rate pir-rate [cir cir-rate]
slope-policy name
Example: *A:ALU-1# configure qos sap-ingress 100 queue 2 create
config>qos>sap-ingress>queue$ adaptation-rule pir
closest cir closest
config>qos>sap-ingress>queue$ cbs 1500
config>qos>sap-ingress>queue$ high-prio-only 10
config>qos>sap-ingress>queue$ mbs 10
config>qos>sap-ingress>queue$ rate 2500 cir 2500
config>qos>sap-ingress>queue$ slope-policy
"SlopePolicyIngress"
config>qos>sap-ingress>queue$ exit
The following output displays the queue configuration for service ingress policy 100:
ALU-1>config>qos# info
#--------------------------------------------------
echo "QoS Policy Configuration"
#--------------------------------------------------
...
sap-ingress 100 create
description "Used on VPN SAP"
queue 1 priority-mode create
exit
queue 2 priority-mode create
rate 2500 cir 2500
mbs 10
cbs 1500
high-prio-only 10
...
#--------------------------------------------------