Slope QoS Policies
376
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
network-queue default 5
network-queue default 6
network-queue default 7
network-queue default 8
network-queue default 9
network-queue default 10
network-queue default 11
network-queue default 12
network-queue default 13
network-queue default 14
network-queue default 15
network-queue default 16
===============================================================================
*A:ALU-1#
Table 51 Slope Policy Command Output Fields
Label Description
Policy The ID that uniquely identifies the policy
Description A text string that helps identify the policy’s context in the
configuration file
Time Avg The time average factor, which is the exponential weight factor
used in calculating the average queue size. The
time_average_factor parameter is non-user-configurable, and is
set to a system-wide default value of 3.
High Slope Parameters
Start Avg The high-priority WRED/RED slope position for the queue
average usage value where the packet discard probability starts
to increase above zero
Max Avg The high-priority WRED or RED slope position for the queue
average usage value where the packet discard probability rises
directly to one
Admin State enabled - the administrative status of the WRED/RED slope is
enabled
disabled - the administrative status of the WRED/RED slope is
disabled
Max Prob. The high-priority WRED/RED maximum discard probability (at
slope position max-avg)
Low Slope Parameters
Start Avg The low-priority WRED/RED slope position for the queue
average usage value where the packet discard probability starts
to increase above zero
To Next Page
Loading...
