Service Egress and Ingress QoS Policies
290
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
Any changes made to an existing policy, using any of the sub-commands, will be applied
immediately to all egress SAPs where this policy is applied. For this reason, when many
changes are required on a policy, it is highly recommended that the policy be copied to a work
area policy-id. That work-in-progress policy can be modified until complete and then written
over the original policy-id. Use the config qos copy command to maintain policies in this
manner.
The no form of this command deletes the sap-egress policy. A policy cannot be deleted until
it is removed from all service SAPs where it is applied. When a sap-egress policy is removed
from a SAP, the SAP will revert to the default sap-egress policy-id 1.
Parameters policy-id — uniquely identifies the policy. The policy-name cannot be used to create the
policy, but it can be used to reference a policy that already exists.
Values 1 to 65535, or policy-name (up to 64 characters)
Default n/a
create — keyword used to create a service egress QoS policy
fc
Syntax [no] fc fc-name [create]
Context config>qos>sap-egress
Description The fc fc-name mode within the SAP egress QoS policy is used to contain the explicitly
defined queue mapping and dot1p marking commands for fc-name. When the mapping for
fc-name points to the default queue and the dot1p marking is not defined, the mode for
fc-name is not displayed in the show configuration or save configuration output unless the
detail option is specified.
The no form of the command removes the explicit queue mapping and dot1p marking
commands for fc-name. The queue mapping reverts to the default queue for fc-name, and the
dot1p marking (if appropriate) uses the default of 0.
Default n/a
Parameters fc-name — specifies the forwarding class queue mapping or dot1p marking is to be
edited. The value given for fc-name must be one of the predefined forwarding classes
in the system.
Values be, l2, af, l1, h2, ef, h1, nc
create — keyword used to create a SAP egress forwarding class policy
Note: If the egress port encapsulation type is qinq, the SAP type is X.Y, and one tag already
exists and a new tag must be added, then the new outer tag’s dot1p bits will be set to the
inner tag’s dot1p bits value. For all other port types and SAP types, new tags will have a
dot1p-bits value of 0 if the default policy is used.
To Next Page
Loading...
