Nokia 7705 - Page 293

Quality of Service Guide Service Egress and Ingress QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 293
The no form of the command removes the queue-id from the service egress policy. Removing
the queue-id also removes it from any existing SAPs using the policy. If any forwarding
classes are mapped to the queue, they revert to the default queue.
When a queue is removed, pending accounting information for each service egress queue
created due to the definition of the queue in the policy is discarded.
Default n/a
Parameters queue-id — the queue-id for the service egress queue, expressed as a decimal integer.
The queue-id uniquely identifies the queue within the policy.
Values 1 to 8
Default n/a
queue-type — the expedite, best-effort and auto-expedite queue types are mutually
exclusive. Each defines the method that the system uses to service the queue from
a hardware perspective. A keyword must be specified at the time the queue is
created in the service egress policy. If an attempt is made to change the keyword
after the queue is initially defined, an error is generated.
expedite — the queue is treated in an expedited manner independent of the forwarding
classes mapped to the queue
best-effort — the queue is treated in a non-expedited manner independent of the
forwarding classes mapped to the queue
auto-expedite — the system auto-defines the way the queue is serviced by the
hardware. When auto-expedite is defined on the queue, the queue is treated in an
expedited manner when all forwarding classes mapped to the queue are configured
as expedited types nc, ef, h1 or h2. When a single non-expedited forwarding class
is mapped to the queue (be, af, l1 and l2) the queue automatically falls back to non-
expedited status.
Values expedite, best-effort, auto-expedite
Default auto-expedite
create — keyword used to create a service egress queue policy
scope
Syntax scope {exclusive | template}
no scope
Context config>qos>sap-egress
Description This command is used to enter the scope of the policy. The scope of the policy cannot be
changed if the policy is applied to one or more services.
The no form of this command sets the scope of the policy to the default of template.