Quality of Service Guide Service Egress and Ingress QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 323
cir-rate — overrides the default administrative CIR used by the queue. When the rate
command is executed, a cir-rate setting is optional. When the rate command has not
been executed or the cir keyword is not explicitly specified, the default CIR (0) is
assumed. Fractional values are not allowed and must be given as a positive integer.
The CIR rate has a minimum value of 8kb/s.
Values 0 to 100000000 | max
Default 0
slope-policy
Syntax slope-policy name
no slope-policy
Context config>qos>sap-ingress queue
config>qos>sap-egress queue
Description This command specifies the slope parameters controlling the queue.
Default slope-policy default
Parameters name — the name of the slope policy
Values Valid names consist of any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains
special characters (#, $, spaces, etc.), the entire string must be
enclosed within double quotes.
Note: If a PIR rate lower than 8 kb/s is specified, it is rounded up to this minimum value.
Note: If a CIR rate lower than 8kb/s is specified, it is rounded up to this minimum value (with
the exception of 0, which does not get rounded up).
To Next Page
Loading...
