Slope QoS Policies
370
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
7.4.2.1.2 Slope Policy QoS Commands
slope-policy
Syntax [no] slope-policy name [create]
Context config>qos
Description This command enables the context to configure a QoS slope policy.
Default slope-policy “default”
Parameters name — the name of the slope policy
Values Valid names consist of any string up to 32 characters long
composed of printable,
7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double
quotes.
create — keyword used to create a slope policy
high-slope
Syntax [no] high-slope
Context config>qos>slope-policy
Description The high-slope context contains the commands and parameters for defining the high-priority
Weighted Random Early Detection (WRED) or Random Early Detection (RED) slope graph.
Each queue supports a high-priority WRED/RED slope for managing access to the queue for
low-priority or out-of-profile packets.
The high-slope parameters can be changed at any time and the affected queue high-priority
WRED/RED slopes will be adjusted appropriately.
The no form of this command restores the high slope configuration commands to the default
values. If the commands within high-slope are set to the default parameters, the high-slope
mode will not appear in save config and show config output unless the detail parameter is
present.
To Next Page
Loading...
