ATM QoS Traffic Descriptor Profiles
396
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
policing
Syntax [no] policing
Context config>qos>atm-td-profile
Description This command determines whether ingress traffic is policed. Policing is valid for CBR, rt-VBR,
nrt-VBR, and UBR. This policing is cell-based.
Default disabled
service-category
Syntax service-category service-category
Context config>qos>atm-td-profile
Description This command is used to configure an ATM service category attribute of an ATM traffic
descriptor profile.
Default ubr
Parameters service-category — Table 56 describes the supported ATM service categories on the
16-port T1/E1 ASAP Adapter card, 32-port T1/E1 ASAP Adapter card, 4-port DS3/E3
Adapter card, 4-port OC3/STM1 Clear Channel Adapter card, and 2-port OC3/STM1
Channelized Adapter card.
P0_1and S0 PIR in kb/s; applies to CLP=0 and CLP=1
cell flows; non-conforming CLP=0 cell
flows are discarded
SIR in kb/s; applies to CLP=0 cell flows
only
rt-VBR and nrt-VBR
P0_1andS0_Tag PIR in kb/s; applies to CLP=0 and CLP=1
cell flows; non-conforming CLP=0 cell
flows are tagged to CLP=1 cell flows
SIR in kb/s; applies to CLP=0 cell flows
only
rt-VBR and nrt-VBR
P0_1and S0_1 PIR in kb/s; applies to CLP=0 and CLP=1
cell flows
SIR in kb/s; applies to CLP=0 cell flows
only
rt-VBR and nrt-VBR
Table 55 Traffic Descriptor Type Command Parameters (Continued)
Descriptor-type
Value
Rates Interpretation Applicable Service
Categories
To Next Page
Loading...
