QoS Fabric Profiles 
420
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
 
9.3.2.1.2 QoS Fabric Profile Commands
fabric-profile
Syntax fabric-profile policy-id [aggregate-mode | destination-mode] [create]
no fabric-profile policy-id 
Context config>qos
Description This command is used to configure a QoS fabric profile policy.
The default mode is aggregate-mode, which means that the access-ingress and network-
ingress fabric shapers on all adapter cards are set to the same rate, either by default or via 
the aggregate-rate command. Selecting destination-mode allows each adapter card to 
have its fabric shapers set to a different rate for unicast traffic and a common rate for BMU 
traffic, either by default or via the dest-mda rate command. 
The default fabric profile is preconfigured and non-modifiable. It cannot be deleted. All other 
fabric profiles must be explicitly created before use. 
The create keyword must follow each new profile configuration.
Default policy-id 1
aggregate-mode
Parameters policy-id — the index identifier for a fabric profile policy
Values 1 to 256
aggregate-mode — assigns the aggregate fabric profile mode to the specified fabric 
profile 
destination-mode — assigns the per-destination fabric profile mode to the specified 
fabric profile
create — keyword used to create a fabric profile policy
aggregate-rate 
Syntax aggregate-rate aggregate-rate [unshaped-sap-cir cir-rate] 
Context config>qos>fabric-profile
Description This command sets the rate of the fabric shapers in aggregate mode, in kb/s. The aggregate-
rate represents the maximum bandwidth that an adapter card can switch through its fabric 
interface. Each fabric shaper is set to the same aggregate rate. Using the default keyword 
sets the aggregate rate to 200 000 kb/s.