Nokia 7705 - 5.4.13 Upgrading from IPv4 to IPv6

Quality of Service Guide QoS Fabric Profiles
Edition: 01 3HE 11014 AAAC TQZZA 425
network-ingress-aggregate-rate
Syntax network-ingress-aggregate-rate network-ingress-aggregate-rate
Context config>system>qos
Description This command sets the rate for fabric shapers on the 7705 SAR-A, 7705 SAR-Ax,
7705 SAR-H, 7705 SAR-Hc, 7705 SAR-M, 7705 SAR-W, or 7705 SAR-Wx for network
ingress traffic, in kb/s. The rate represents the maximum bandwidth that the node can switch
through its fabric interface. Only aggregate mode is supported.
This command is not supported on the 7705 SAR-X, where the shaper rate is set
permanently to 16 Gb/s.
Default 2000000 (“default”)
Parameters network-ingress-aggregate-rate — the rate of the fabric shapers for network ingress
traffic, in kb/s. Using the default keyword sets the aggregate rate to 2 000 000 kb/s
(2 Gb/s).
Values 1 to 10000000 (10 000 000), or default
Note: The actual supported maximum rates depend on the platform:
• 7705 SAR-A, 7705 SAR-Ax, 7705 SAR-M, 7705 SAR-W, and 7705 SAR-Wx: 5 Gb/s
• 7705 SAR-H: 4 Gb/s
• 7705 SAR-Hc: 2.5 Gb/s
Note: The actual supported maximum rates depend on the platform:
• 7705 SAR-A, 7705 SAR-Ax, 7705 SAR-M, 7705 SAR-W, and 7705 SAR-Wx: 5 Gb/s
• 7705 SAR-H: 4 Gb/s
• 7705 SAR-Hc: 2.5 Gb/s