ACCESS GATEWAY
178 System Administration
You can display up to 5 banners, but they must be defined here. Banners require all the same parameters that
“buttons” use (see Assigning Buttons on page 177), with the addition of 3 (three) more. These are:
Duration – Defines how long the banner is displayed in the ICC.
Start Time – This is an optional parameter that you set if you want to assign a “start” time (for
when the banner is displayed).
Stop Time – This is an optional parameter that you set if you want to assign a “stop” time (for
when the displayed banner closes).
When assigning images and times for banners, refer to Pixel Sizes on page 178 and Time Formats on page
179.
2.
Define the parameters for your banner(s):
Name/Text
Target URL
Image Name (see following note)
Duration (secs)
Start Time (Optional)
Stop Time (Optional)
If you assign (or change) button images or banner images, the Access Gateway must be
rebooted for your changes to take effect.
3.
When finished, click on the Save button to save your changes, click on Save then Reboot
to reboot the
Access Gateway and make the changes take effect immediately, or click on the
Restore button if you
want to reset all the values to their previous state. (Only changes to Image Name definitions require a
reboot).
4.
To return to the previous screen, click on the Configure ICC link.
Pixel Sizes
Use the following parameters when defining images for buttons and banners:
Banners – 373 pixels (width) x 32 pixels (height)
ISP Button – 98 pixels (width) x 26 pixels (height)
Small buttons – 45 pixels (width) x 26 pixels (height)
To Next Page
Loading...
