ACCESS GATEWAY
72 System Administration
1.
Select the Internal Web Server tab.
2.
Enable or disable the SSL Support feature, as required. If you enable SSL Support, you must provide
a valid
Certificate DNS Name.
For more information about setting up SSL, go to Setting Up the SSL Feature on page 251.
SSL support allows for the creation of an end-to-end encrypted link between the Access Gateway and
its clients by enabling the Internal Web Server (IWS) to display pages under a secure link—important
when transmitting AAA information in a network.
Adding SSL support to the Access Gateway requires service providers to obtain digital certificates
from VeriSign™ to create HTTPS pages. Instructions for obtaining certificates are provided by
Nomadix.
To enable SSL Support, your Access Gateway’s flash must include the server.pem,
cakey.pem, and cacert.pem certificate files (the “cacert.pem” file is provided with your
Access Gateway). For assistance, contact Technical Support.
3.
If you want to designate a portal page, you must enable the Portal Page feature; otherwise leave this
feature disabled.
The Portal Page IP or DNS address are added to the IP passthrough list automatically.
4.
If you enabled the Portal Page feature, provide the following supporting information:
Portal Page URL
Parameter Passing (enabled or disabled)
Parameter Signing (including Method, Parameters, and Shared Secret)
See Redirection Parameter Signing on page 74 for more information about parameter
signing.
Portal XML POST URL, target for the NSE’s USER_STATUS XML commands
To Next Page
Loading...
