Nordson ProBlue Flex - Page 4

ProBlue Flex OEM User’s Guide
2
Part 1129255_01
E 2020 Nordson Corporation
Basic Melter Operation 22.......................................
Starting the Melter 22............................................
Shutting Down the Melter 22....................................
Switching the Master Heater and Pump Controls On/Off 23............
Monitoring the Tank Adhesive Level 24............................
Manually Filling the Melter Tank 25................................
Manually Adjusting the System Air Pressure 26...................
To manually adjust system air pressure 26.....................
Setting Up the Melter 27........................................
Defining Runtime Settings 28..................................
Defining Temperature Runtime Setting 28.........................
Enabling/Disabling and Changing Zone Set Point Temperatures 28...
Manually Adjusting System Air Pressure 29.........................
Defining Electronic/Runup Pressure Runtime Settings 30.............
Defining Manual Pressure Adjust Alert Settings 30.................
Defining Electronic Pressure Settings and Monitoring Alert Settings 31
Electronic Pressure Alert and Monitoring 31.......................
Defining Pressure Runup Settings and Monitoring Alert Settings 33...
Pressure Runup General Settings 33..........................
Pressure Runup Output Settings 34...........................
Pressure Runup Alert Threshold Settings 35....................
Pressure Runup Pressure Limits 36............................