Nordson ProBlue Flex - Page 5

ProBlue Flex OEM User’s Guide 3
Part 1129255_01
E 2020 Nordson Corporation
Defining System Settings 37....................................
Additional Information 37.........................................
Defining System Temperature Settings 38..........................
Defining SmartMelt Settings 38..................................
Defining Global Temperature Settings 39.........................
Heaters On Upon Startup 39.................................
Defining the Over/Under Temperature Thresholds 40............
Defining Temperature Setback 41.............................
Defining Setback Settings 42......................................
Manually Entering/Exiting Setback 42............................
Defining Automatic System Setback 43...........................
Defining Manual Setback - Auto Exit Time 44......................
Defining Ready Delay 45.......................................
Defining Level Sensing Settings 46................................
Enabling/Disabling Low Level Alerts and Settings 46...............
Enabling/Disabling Empty Stop 47...............................
Enabling/Disabling Lid Open Alerts and Settings 48................
Defining Fill Settings 49..........................................
Melt-on-Demand and Tank Systems with Optional Fill Settings 49....
Maximum Fill Time and Target Fill Level Settings 49.............
Enabling and Disabling Auto Pump 50..............................
Enabling and Disabling Auto Pump 50...........................
About Adhesive Tracking System (ATS) 51.........................
Theory of Operation 52.........................................
ATS Product Setup 52...........................................
Enabling Flow Monitoring 53....................................
Calibrating the Flow Meter 54...................................
Adhesive Settings 54........................................
Defining Product and Trigger Settings 55.........................
Product Settings 55.........................................
Trigger Settings 57............................................
Defining Adhesive Tracking System Alarms 58....................
Troubleshooting Adhesive Tracking System 60......................
Understanding the ATS PCA Board LEDs 60......................
General and Flow Control Alarms 63.............................
About System I/O 65.............................................
Assigning Inputs 65...........................................
Assigning Remote Recipe Inputs 66.............................
Assigning Outputs 68..........................................
Assigning Light Tower Outputs 69...............................
Modifying External Zone Names 70................................
Modifying User Management Access Rights 71......................
Defining and Modifying Heat Schedules 71..........................
Defining and Modifying Shift Schedules 72..........................
Defining Network Access 73......................................
Defining WiFi Access 74.......................................
Defining PLC Access 76........................................
Defining PLC Communications 77...............................
Connecting Profinet, Ethernet/IP and Modbus TCP 79..............
Defining Web Access 81.......................................
About System Preferences 82
....................................
Uploading a .PLC File from BBconn Cloud File to a Melter 83..........
Backward Compatibility 83.....................................
Editing a .PLC File from BBconn Cloud 84.......................