Glossary
D-12
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
Processing Temperature
The processing temperature is prescribed or recommended by the material
manufacturer. It can be found in the product information and/or in the
Material Safety Data Sheet (MSDS)
PROFIBUS
Internationally standardized serial field bus with master-slave subscribers.
Nordson melters (slave) with a PROFIBUS DP interface can be controlled
remotely by one of the customer’s control units (master).
Proper Disposal
Disposal of all types of waste in compliance with all local regulations.
Proportional Pressure Control Valve
Electropneumatic component that enables control of pneumatic pressure
with an electrical variable (usually control voltage).
Protective Gas
Refer to Inert Gas.
Pt 100
Abbreviation for a platinum based resistance temperature sensor. At a
temperature of 0° C (32° F), it has an electrical resistance of 100 W.
Pull-in Delay
1. The time between the signal to switch on the gun/application head and
the beginning of material application.
2. The time between when the voltage is turned on and when the delay
relay is actually engaged.
PUR
Refer to Polyurethane Hot Melt Adhesive.
Rated Current
The setpoint for current to a unit, determined by standards or as agreed
upon by the manufacturer and the customer.
To Next Page
Loading...
Need help?
General
