Introduction
2-4
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
Note on Manual
The first generation IPC has been replaced by the new model IPC
(generation 2). The instructions in the manual all refer to the new model,
with the exception of Appendix B. When ordering spare parts, state the
P/N on the control panel ID plate.
Features that the customer may not have purchased − depending on the
configuration of the melter − are also described in the section Operation.
In this case they are not visible on the control panel.
Definition of Terms
Interface Standard I/O
Component designation: XS 2
Transmits the digital input and output signals between the parent machine
and the Nordson melter.
Interface Key-to-line Mode
Component designation: XS 5 (one line speed signal input for all motors) or
XS 5.1, XS 5.2, XS 5.3 and XS 5.4 (option: separate line speed signal
inputs).
NOTE: Key-to-line is also referred to as Automatic mode in Nordson
literature.
In key-to-line the motor/pump speed is regulated synchronously to the
speed of the parent machine.
Encoder
The encoder compiles the line speed of the parent machine. It supplies a
certain number of electrical pulses per revolution. The frequency is a
measure of line speed.
CAUTION: The cable length may not be modified; this could cause
incorrect evaluation of the line speed, resulting in incorrect material
applications.
To Next Page
Loading...
Need help?
General
