Glossary
D-13
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
Release Coating
Largely prevents hot melt adhesive from burning onto the surface and
makes it easier to clean the application system parts coming into contact
with the adhesive.
Residual Risks
Hazards that can pose a danger to the user, even when all safety
regulations for manufacturing a product are followed and when the unit is
used only as intended. Residual risks are noted - as extensively as the
manufacturer is aware of them - in the manual and/or with waning signs on
the unit.
Resistance Temperature Sensor
Component with an electrical resistance, the value of which changes as a
factor of the temperature. Nordson units use the models Pt 100 and Ni 120.
Reverse Mode
A pump motor operates counter to the direction of material feeding.
Prevents material from dripping.
RPM
Revolutions per minute, same as min
−1
= 1/min.
Safety Valve
A valve that prevents the material pressure from exceeding a preset value.
Safety Valve Plate
A component in which material circulates when the installed safety valve is
open.
Set Time
The amount of time that the adhesive needs from application to complete
hardening.
SI
Système International d’ Unités (international standardization system).
To Next Page
Loading...
Need help?
General
