What are Type Codes? Type Codes
NFS-3030 Programming Manual P/N 51345:C 11/4/03 123
Appendix G: Type Codes
G.1 What are Type Codes?
Type Codes are software selections for initiating devices (detectors and monitor modules) and
output devices (control modules, NACs, and Panel Circuits). Some Type Codes are self-
explanatory; that is, the Type Code matches the function of the device, such as a “Monitor” for a
monitor module, “Smoke(photo)” for a photoelectric detector, and so on. Type codes also provide
special functions, such as activating switches, solenoids, and control panel functions. FlashScan
devices are assigned a special FlashScan code.
G.2 How to Select a Type Code
Type Codes are selected at the Point Programming screens. Refer to the Point Program section of
this manual for instructions.
This appendix contains detailed descriptions of Type Codes for input and output devices, as listed
below:
Type of Device
Refer to
page
"Type Codes for Intelligent Detectors"Intelligent
Detectors
124
Monitor Modules"Type Codes for Monitor Modules" 125
SLC and Panel Circuit Outputs 126
FlashScan Codes 127
www.PDF-Zoo.com
To Next Page
Loading...
Need help?
General
