Program Delete Program
52 NFS-3030 Programming Manual P/N 51345:C 11/4/03
3.5 Delete Program
Press the DELETE PROGRAM MENU at the PROGRAM/ALTER STATUS MENU menu to
display the screen below.
Figure 3.44 Delete Program Menu Screen
Soft Keys
CLEAR ALL PROGRAMMING: Press to remove all panel, panel module, loop, point and ACS
programming information, as well as logic and trouble zone equations. Pressing this key removes
everything except passwords. A confirmation screen will display asking the user to confirm the
deletion command. Pressing this key causes a reboot.
CLEAR:PANEL Press to remove all programmed panel setting information from control panel
memory. This does not remove ACS programming. A confirmation screen will display asking the
user to confirm the deletion command. Pressing this key causes a reboot.
CLEAR:PANEL MODULES Press to remove all panel module programming information. A
confirmation screen will display asking the user to confirm the deletion command. Pressing this
key causes a reboot.
CLEAR LOOPS Press to scroll through the options: ALL, LOOP 1, LOOP 2,...., LOOP 10. Stop at
the desired option. Press ACCEPT to delete all loop programming for the selected option. Pressing
this key causes a reboot.
DELETE POINT To delete a point, press this soft key to display the Delete Point screen. Pressing
this key may cause a reboot.
CLEAR ACS: Press to remove all ACS programming from panel memory. A confirmation screen
will display asking the user to confirm the deletion command. Pressing this key causes a reboot.
ACCEPT: Press to clear all programming for the selected loop option for CLEAR LOOPS. A
confirmation screen will display asking the user to confirm the deletion command.
DELETE PROGRAM MENU
CLEAR: PANEL CLEAR ALL PROGRAMMING
CLEAR: PANEL MODULES CLEAR ACS
CLEAR LOOPS: ALL ACCEPT
DELETE POINT BACK
www.PDF-Zoo.com
To Next Page
Loading...
