Autoprogram Menu Program
NFS-3030 Programming Manual P/N 51345:C 11/4/03 57
instead of the message below.
Figure 3.49 Autoprogram Confirmation Screen (New SLC Point)
Soft Keys
YES: Press this soft key to install the new point into the panel’s database.
EDIT: Press this soft key to advance to the point programming menu for the new point. (This
option is available for SLC points only, not for panel points. The
EDIT soft key will not appear for
panel modules).
NO: Press if the point will not be installed.
Error and Discrepancy Resolution
Pressing the REVIEW soft key will bring up screens that provide the means to resolve any errors or
discrepancies found during autoprogram.
Figure 3.50 Autoprogram Confirmation Screen (Missing Point)
Display
This screen will display either the SLC device address or the panel circuit module address when a
previously installed/programmed point does not respond during a subsequent Autoprogram.
Soft Keys
YES: Press to delete the point information from the panel’s database.
AUTOPROGRAM CONFIRMATION
NEW DEVICE FOUND AT LXXXDXXX
ADD POINT?
YES NO
EDIT BACK
AUTOPROGRAM CONFIRMATION
NO DEVICE FOUND AT LXXDXXX
DELETE POINT?
YES NO
BACK
www.PDF-Zoo.com
To Next Page
Loading...
Need help?
General
