Oce TDS600 - Installation procedure for Unix systems

Océ Power Logic: Remote Logic 113
Installation procedure for Unix systems
Océ Remote Logic is set up to be platform independent. It runs on a variety of
operating systems providing that a java runtime environment is available for
that platform. The java runtime environment must be installed by a user with
system administrator privileges, depending on Java Virtual Machine (VM). It
is also assumed that Océ Remote Logic is installed by an experienced user.
Note:
OS = Operating System, JRE = Java Runtime Environment
▼
▼▼
▼
Install Océ Remote Logic’
1
Check if a java runtime environment (JRE) is installed on the system. The
preferred version is JRE 1.1.8. Below you can find some links to JRE's for
various UNIX platforms.
2
Unpack the contents of the file ‘RemoteLogic_vX.tar’, from the directory
Products/remotelogic/UNIX, to a subdirectory on the system.
3
Use ‘tar xvf RemoteLogic_vX.tar’ to unpack.
4 Set the environment variable ‘RL_VM_HOME’ to point to the installation of
the JVM.
5
Run the file ‘remotelogic’ with the applications as parameters. (e.g.
remotelogic QM SCP SE to start the three applications), or use ‘remotelogic
AL’, for the application launcher.
Note:
If you do not supply any options, a short help text is displayed.
UNIX versions and the required JRE
UNIX version OS version JRE Default installation directory
IBM AIX 4.1.5 1.1.6 /usr/jdk_base
IBM AIX 4.2.1 1.1.8 /usr/jdk_base
IBM AIX 4.3.3 + fix 1.2.2 /usr/jdk_dev2
IBM AIX 4.3.3.10 + fix 1.3.0 /usr/jdk_java130
SUN Solaris 2.6 1.1.6
HP-UX 10.20 1.1.3
LINUX 1.0 1.1.3
LINUX 1.2 1.1.8