Oce TDS600 - Switch the Océ TDS600 Scanner off

UsetheOcéTDS600toscan 59
▼
▼▼
▼
Switch the Océ TDS600 scanner on
1
Set the on/off switch at the front of the scanner to position ‘1’., (see figure 24).
The green LED will be on.
2
The message ’Ready to copy’ appears.
▼
▼▼
▼
Switch the Océ Power Logic controller on
1
Press the on/off button on the controller, (see figure 25).
2
Press the on/off button on the monitor.
The controller starts up.
Switch the Océ TDS600 scanner off
▼
▼▼
▼
Switch the Océ TDS600 scanner off
1
Set the on/off switch at the front of the scanner to position ‘0’.
▼
▼▼
▼
Switch the Océ Power Logic controller off
1
Select the ‘Shut down’ option from the Océ System Control Panel.
2
Switch off the controller and the monitor (see figure 25).
Wait at least 5 seconds before you restart the Océ TDS600.