Oce TDS600 - Scanned files

UsetheOcéTDS600toscan 81
Note:
The ‘Base name’ may contain ‘###’ for automatic file naming. The
‘###’ will be replaced by an ascending number. You may place as many
dots in the ‘Base name’.
4 Check or uncheck the ‘Add appropriate file extension’ check box to add or
respectively leave out an appropriate file extension. The file extension can be
set in the Océ Settings Editor see page 225.
5 Click Ok to accept the settings.
▼
▼▼
▼
Set / Change destination properties
1
Select a destination.
2
Open the ‘File’ menu and select ‘Properties’ or click the ‘Properties’ button on
the toolbar (see figure 42).
[42] ‘Properties’ button on the toolbar
The‘Destinationproperties’screenappearsasinfigure40onpage79.
3 Change the destination properties as described in ‘Create a destination’ on
page 78.
Scanned files
The right pane of the Océ TDS600 Scan Manager contains the scanned files
and additional information about the files. You can view, print and delete these
files. You can also view the file properties.
▼
▼▼
▼
View a scanned file
1
Select a file in the right pane.
2
Open the ‘File’ menu and select ‘View’ or click the ‘View’ button on the
toolbar (see figure 43).
[43] ‘View’ button on the toolbar
Océ View Station LT (see ‘Océ View Station LT’ on page 86) starts up and
displays the file.
Note:
When you scan to file the controller Océ View Station LT starts
automatically, showing the result of the scan.
▼
▼▼
▼
Print a scanned file
1
Select a file in the right pane.