Oce TDS600 - Page 80

80 Océ TDS600 Multifunctional Digital System User Manual
A key operator can determine whether a destination can be modified by an
anonymous user. This is done by locking and unlocking a destination.
▼
▼▼
▼
Lock a destination
1
Select a destination.
2
Open the ‘File’ menu and select ‘Properties’.
3
Check the ‘Locked’ check box.
4
Click Ok to accept the destination settings.
The destination properties are now locked.
Note:
This option is only available if you are logged on as a Key operator (see
‘User modes’ on page 117).
▼
▼▼
▼
Unlock a destination
1
Select a destination.
2 Open the ‘File’ menu and select ‘Properties’.
3 Uncheck the ‘Locked’ check box.
4 Click Ok to accept the destination settings.
The destination properties are now unlocked.
Note:
This option is only available if you are logged on as a Key operator (see
‘User modes’ on page 117).
▼
▼▼
▼
Delete a destination
1
Select a destination.
2
Open the ‘File’ menu and select ‘Delete’ or click the ‘Delete’ button on the
toolbar (see figure 41).
[41] ‘Delete’ button on the toolbar
The selected destination is deleted.
Note:
This option is only available if you are logged on as a Key operator or
as a Repro operator.
Note:
You are not able to delete the last destination.
▼
▼▼
▼
Define file name
1
Select a destination.
2 Open the ‘File’ menu and select ‘Properties’.
The ‘Destination properties’ screen appears as in figure 40 on page 79.
3 Enter a name in the ‘Base name’ textbox.