Oce TDS600 - Before you begin; Switch the Océ TDS600 printer and scanner on

38 Océ TDS600 Multifunctional Digital System User Manual
Before you begin
You must switch on the Océ TDS600 printer, scanner and the Océ Power Logic
controller before you can print. You do not have to use a specific order in which
you switch on or off the Océ TDS600 printer, scanner and the Océ Power Logic
controller.
Note:
Chapter 1 (see ‘Printer operator panel’ on page 26) explains the printer
operator panel.
Switch the Océ TDS600 printer and scanner on
You switch on the Océ TDS600 printer and scanner with the on/off switch. The
switch of the is at the rear of the printer. The switch of the scanner is
underneath the original feed table.
[7] On/off switch on the printer