Oce TDS600 - Interrupt a Print Job; Select a Language

32 Océ TDS600 Multifunctional Digital System User Manual
5 Use the up/down buttons to select the Special option for the specified roll or
sheet feeder.
6 Press the on line button to put the printer on line again. The printer now knows
that the specified roll or sheet feeder contains special material.
Interrupt a print job
The red ‘Stop’ button on the Océ TDS600 Printer operating panel interrupts the
active print process. You can cancel or continue the current print job.
▼
▼▼
▼
Cancel a print job
1
Press the ‘Stop’ button.
A dialogue is displayed informing you that you can press on line to continue
or stop to cancel the job.
2 Press the ‘Stop’ button again to cancel the current job.
Note:
In general, the printer cannot be stopped immediately because the
started prints have to be finished. Printing will be stopped at the end of the
page.
▼
▼▼
▼
Continue a print job
1
Press the ‘Stop’ button.
A dialogue is displayed informing you that you can press on line to continue
or stop to cancel the job.
2 Press the ‘On line’ button to continue the current print job.
Select a language
On the operating panel of the Océ TDS600 Printer you can specify which
language you want to use for displaying printer information, such as status and
error messages.
By default, you can choose between two languages, which have been defined
for your system by the key operator (see ‘First language’ on page 192).
Note:
If the key operator has specified only one language, it will not be possible
for you to choose. In that case the language option will not appear on the
operating panel.