Problem solving 271
Note:
If the cut sheet feed covers are still flashing on the display, re-check the
sheet feeder section.
Paper jam in the roll feed section
▼
▼▼
▼
How to clear a jam in the roll compartments
1
Open the appropriate roll compartment.
Note:
Only one compartment can be open at a time.
2 Remove any jammed printing material from the paper path (see figure 164)
and, if necessary, pull back the paper and rewind it.
Note:
Occasionally, a jam may occur before the printing material has been
cut. In that case, you can cut the material manually by pressing the
appropriate green load button in the roll compartment.
3 Reloadtherollifthesystemasksyoutodoso(see‘Loadrollsofcopy
material’ on page 241).
4 Close the roll compartment again.
Note:
If the roll feed covers are still flashing on the display, re-check the roll
feed section.
Paper jam in the manual feed
▼
▼▼
▼
How to clear a jam in the manual feed
1
Open the manual feed by tilting it towards you (see figure 165).
[165] Opening the manual feeder
2 Remove any jammed printing material.
To Next Page
Loading...
