Problem solving 287
[190] Situation A: No mechanical errorSituation B: Mechanical error
4
If there are, remove the tape strips in the reinforcement unit.
Note:
If the protection sheet is not on the reinforcement strip (see situation
A in figure 190), there is no mechanical error and you should insert a new
tape roll as described in ‘A new tape roll’ on page 254. If this error
frequently occurs you should call the Océ service organisation (see ‘Other
problems (call service)’ on page 288).
5
Remove all tape between the rollers and knives (see figure 191).
[191] Removing the tape
6 Lead a new trailing edge of tape between the rollers and knives. For more
information see ‘A new tape roll’ on page 254.
To Next Page
Loading...
