Oki C542dn Advanced Manual

- 132 -
5. Operating Management/ Specifications
• Default Mode
• Operation Clear
• Sound Control
• Local Interface*
1
• System Setup
• Power Save
Manage Unit
Item Factory
default
setting
Description
Default Mode Home Sets the default mode screen of this machine.
Item Factory
default
setting
Description
Operation Timeout 3 Sets time for automatic reset of screen to begin.
Available range: 1 to 10 minutes
Clear After Job OFF Sets whether to reset after job is completed.
Item Factory
default
setting
Description
Key Touch Tone Volume Middle Sets the volume of the key-touch tone.
JAM Buzzer Volume Middle Sets the volume for the paper jam alert tone.
AirPrint Buzzer Volume Low Sets the AirPrint confirmation operation sound.
Item Factory
default
setting
Description
USB Menu Soft Reset Disable Sets whether to enable the soft reset command.
Speed 480Mpbs Selects the maximum transfer speed of USB interface.
Offline Receive Disable Set whether to receive data in offline state or in recoverable
error state.
Serial Number Enable Sets whether to use a USB serial number.
Connected
Host
Normal Sets a host to be connected.
Item Factory
default
setting
Description
Access Control Disable Sets access control.
Default Authent. Method Sett. Local Name Available only when [Access Control] is set to [Enable].
Unit of Measure Millimeter or
Inch
Selects a displayed unit (millimeter / inch).
Default Paper Size A4 or Letter Sets the default paper size.
Date Format dd/mm/yyyy or
mm/dd/yyyy
Sets the date format.
Allow All Reports To Print Disable Sets whether to allow printing reports with personal
information.
Near Life LED Enable Sets whether to light an LED if a near life warning occurs.
Status in Near Life Enable Sets whether to display a message if a near life warning
occurs.
USB Memory Interface Enable If [Disable] is set, the print from USB Memory function cannot
be used.
Panel Brightness During
Operating
7 Sets the LCD panel brightness.
Available range: 1 to 7 (1 increments)
Panel Brightness While Power
Save
0 Sets the LCD panel brightness.
Available range: 0 to 7 (1 increments)
Panel Calibration Execute Executes LCD panel calibration.
Item Factory
default
setting
Description
Power Save Time 1 minute Sets when to enter Power Save mode.
Sleep Time 15 minutes Sets when to enter Sleep mode.
Auto Power Off Time 4 hours Sets when to enter Auto Power Off.
Silent Mode ON Specifies a print preparation operation when entering standby
status from Sleep mode.
If [ON] is set: it is quiet as there is no print preparation.
If [OFF] is set: there is a rotation noise of the image to perform
print preparation but you can start first printing early.
ECO Mode*
1
ON If [ON] is set: Printing starts even before the temperature of the
fuser reaches the prescribed degrees, if the job is small.
If [OFF] is set: Printing starts after the temperature of the fuser
reaches the prescribed degrees.

Oki C542dn Specifications

General

Brand	Oki
Model	C542dn
Category	Printer
Language	English