- 203 -
7. Utility Software
Setting to Send an E-mail Alert Regularly
1
Open the Web page of this machine.
Open the Web Page of This Machine
2
Log in as the administrator.
3
Select [Admin Setup].
4
Select [Network] > [E-mail] > [Alert Settings].
5
Enter an e-mail address to receive a notification in [Failure Notification
Settings].
6
Click [Setting] of the entered e-mail address.
If you want to apply the notification conditions to another address, click [Copy].
7
Select [Periodically] in [Way of E-mail Alerting], and then click [To Step 2].
8
Specify detailed settings by following the on-screen instructions.
9
Click [OK].
10
Click [View a summary of current configuration] to check the current settings,
and then click [x] to close the window.
You can check the current settings of up to two addresses in the main window. Select
the address you want to check from the list box.
11
Click [Submit].
The new settings take effect when the network function of this machine restarts.
If any failure that is not eligible for notification, an e-mail is not sent.
If you use an SNMP manager that supports SNMPv3, you can encrypt the machine
management with SNMP.
1
Open the Web page of this machine.
Open the Web Page of This Machine
2
Log in as the administrator.
3
Select [Admin Setup].
4
Select [Network] > [SNMP] > [Settings].
5
Specify detailed settings by following the on-screen instructions.
6
Click [Submit].
The new settings take effect when the network function of this machine restarts.
You can confirm and change the machine settings with a commercially available SNMP manager tools. For the MIB
in the machine, refer to the "Software DVD-ROM", and check the MIB definitions file in the [Misc] > [MIB Files] folder.
Using SNMPv3
To Next Page
Loading...
Need help?
General
