- 18 -
1. Basic Operations
Easy Setup
In [Easy Setup], you can change the settings of date/time, network by using [Device Settings]
on the touch panel.
1
Press [Device Settings] on the touch panel.
2
Press [Easy Setup].
3
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "999999"
respectively.
4
Follow the on screen instructions.
• Language Setting
• Date/Time Setting
• Admin Password
• Network Setting
Item Description
Language Setting Sets the language that is displayed on the operator
panel.
Item Description
Time Zone Sets the GMT time zone.
Daylight Saving Sets daylight saving to ON or OFF.
Server SNTP Server (Primary) Sets the SNTP server to use for setting the current date
and time. You can enter up to 64 characters.
SNTP Server (Secondary)
Manual Date Sets the current date and time manually.
Time
Item Description
New Password
Enter Password (Verify)
Changes the administrator password. 6 to 12 characters
can be used.
Item Description
Enabling Default Gateway (If wireless LAN module fitted) Sets which default gateway to be enabled between wired
LAN or wireless LAN.
Wireless
Setting (If
wireless LAN
module fitted)
WPS WPS-PBC WPS-PBC is executed.
WPS-PIN WPS-PIN is executed.
Searc
h
A list of access point name
found in the search
Displays a list of wireless LAN access points' names that
are found in a search.
Manual Setup SSID Enter an SSID.
Security Selects the security of the wireless LAN function.
"WPA-EAP" and "WPA2-EAP" can be set only in Web.
WEP Key Enter WEP Key.
Displays if [WEP] is selected for [Security].
WPA
Encryption
Type
Select a WPA/WPA2-PSK or WPA2-PSK encryption
type.
Displays if [WPA/WPA2-PSK] or [WPA2-PSK] is selected
for [Security].
WPA Pre-
shared Key
Enter the Pre-shared Key.
Displays if [WPA/WPA2-PSK] or [WPA2-PSK] is selected
for [Security].
Reconnect Wireless reconnection is executed.
Obtaining IP address Sets to obtain the IP address automatically or manually.
IP Address Sets the IP address. You can enter up to 15 characters.
Subnet Mask Sets the subnet mask. You can enter up to
15 characters.