EasyManuals Logo

Oki C9500 User Manual

Oki C9500
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #118 background imageLoading...
Page #118 background image
41956001TH Rev.6 118 /
Oki Data CONFIDENTIAL
3 Paper size error
Is paper of regulated size being used?
No Use paper of regulated size.
Yes Is a jam detected by the entrance FF sensor or paper width sensor?
Yes Remove the jammed paper.
No Is the entrance FF sensor lever functioning properly?
No Place the faulty sensor lever.
Yes Is the entrance FF sensor functioning properly?
(Check the FSENS connector pin signal on the engine board (K7N PWB).)
Pin 4: Entrance FF sensor
No Check the cable connections, then replace the sensor board (R71 PWB).
Yes Is the entrance belt sensor functioning properly?
No Place the faulty sensor lever.
Yes Is the entrance belt sensor functioning properly?
(Operate the sensor lever and confirm that the sensor functions properly in the switch scan
test in the system maintenance mode. Also check the FSENS connector pin signal on the
engine board (K7N PWB).)
Pin 6: Entrance belt sensor
No Check the cable connections, then replace the sensor board (R71 PWB).
Yes Are all paper size detection switch on the size detection board (PXC-PWB) functioning
properly?
(Press the paper size detection switch and check the PSIZE connector pin signal on the
engine board.)
Pin 3: Paper size detector 1
Pin 4: Paper size detector 2
Pin 5: Paper size detector 3
Pin 6: Paper size detector 4
No Check the cable connections, then replace the paper size detection board (PXC-PWB).
Yes Check the cable connections, then replace the engine board.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oki C9500 and is the answer not in the manual?

Oki C9500 Specifications

General IconGeneral
BrandOki
ModelC9500
CategoryPrinter
LanguageEnglish

Related product manuals