Oki Teriostar LP-1030 - Page 130

130
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu
n
Drawing Size Command (only with HP-GL)
The parameter species PS, IP, or IW to be applied to the drawing size.
If the drawing size of the data is not specied correctly, set this parameter to O.
<Parameter by selecting options>
n
: Default value
O Disables the drawing size command.
n
On (PS) Species the PS value as the drawing size.
On (IP) Species the IP value as the drawing size.
On (IW) Species the IW value as the drawing size.
z
Note that the function of the IP and IW values diers depending on your CAD
application, which may cause print defects. To prevent it, before selecting On (IP) or
On (IW), be sure to check that IP or IW value is obviously specied as the drawing size.
z
When the data includes the PS value at On (IP) or On (IW), the PS value is prioritized.
n
Drawing (only with D-SCAN)
The parameter species drawing print.
<Parameter by selecting options>
n
: Default value
n
NOP Does not perform drawing print.
EOF Performs drawing print.
n
Identify by Paper Number (only with D-SCAN)
With the parameter, the paper number is identied as paper position or paper type.
<Parameter by selecting options>
n
: Default value
O Disables the paper number in the information block.
n
Paper Position Identies the paper number as the paper position.
Paper Type Identies the paper number as the paper type.
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5