Oki Teriostar LP-1030 - Page 48

48
T
Replacing the Roll Paper
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
3
Flange guide Paper ange
Set the roll paper into the Printer.
Hold the roll paper so that the paper end hangs
down from the bottom toward the Printer. Slowly
insert the paper ange while aligning it with the
groove on the ange guide.
Note

Be careful not to drop the roll paper.
4
Insert the end of the roll paper inside
the paper inlet.
By manually rotating the paper ange, feed the
roll paper.
5
Paper feed knob
By rotating the paper feed knob, feed
the roll paper so that a the top of the
roll paper protrude from the printer by
approximately 60 cm (23.63 inch).
60 cm
(23.63 inch)
6
ロール紙の交換
᳈ᤶ㒌
Replacing Roll Paper
4
6
1
32
用紙カット位置
Paper Cut Position
ߛ㒌ԡ㕂
7
5
Cutter
While holding the end of the roll paper,
cut the paper with the cutter.
The Paper Cut Position label is axed to the
left end of the groove for the cutter edge.
Insert the edge of the cutter in the groove above
the label and cut the paper by moving the cutter
along the groove.
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5