C Exp/ISO
MENU Q C Q C
Option Description
Exposure
Shift
Adjust correct exposure separately for each metering mode.
The effects are not visible in the monitor. To make normal adjustments to the
exposure, perform exposure compensation (P.58).
ISO-Auto
Set
[Upper Limit / Default]: Select the upper limit and default value used for ISO
sensitivity when [Auto] is selected for ISO.
[Upper Limit]: Select the upper limit for auto ISO sensitivity selection.
[Default]: Select the default value for auto ISO sensitivity selection.
[Lowest S/S Setting]: Select the shutter speed below which the camera will
automatically raise ISO sensitivity in modes P and A. If set to [Auto], the camera
automatically sets the shutter speed.
Noise Filter Select the amount of noise reduction performed at high ISO sensitivities.
Noise
Reduct.
This function reduces the noise that is generated during long exposures.
[Auto]: Noise reduction is performed at slow shutter speeds, or when the internal
temperature of the camera has risen.
[On]: Noise reduction is performed with every shot.
[Off]: Noise reduction off.
The time required for noise reduction is shown in the display.
[Off] is selected automatically during sequential shooting.
This function may not work effectively with some shooting conditions or subjects.
Noise in images
While shooting at slow shutter speeds, noise may appear on screen. These phenomena occur
when the temperature rises in the image pickup device or image pickup device internal drive
circuit, causing current to be generated in those sections of the image pickup device that are
not normally exposed to light. This can also occur when shooting with a high ISO setting in a
high-temperature environment. To reduce this noise, the camera activates the noise reduction
function.
147
C Exp/ISO
To Next Page
Loading...
Need help?
General
