Open the battery/card compartment cover and connector cover slowly in the orientation
shown in the figure to prevent water droplets from entering the inside of the covers. If water
droplets come into contact with the inside surface of the covers, be sure to wipe them before
use.
Battery/card compartment cover
Connector cover
Storage and maintenance
Do not use chemicals for cleaning, rust prevention, anti-fogging, repair, or other maintenance.
Doing so may break down water resistance.
When you have finished using the camera underwater, firmly close the battery/card
compartment cover and connector cover. After locking the covers, remove the lens ring and
soak the camera in a bucket or other container filled with clean water for about 10 minutes,
then allow it to dry in the shade in a well-ventilated environment.
After using the camera underwater, do not allow 60 or more minutes to pass without soaking
it in clean water. Failure to observe this caution may result in damage to the camera's
appearance and deterioration of its water resistance.
To maintain water resistance, we recommend replacing the waterproof seals once a year. (You
will be charged for replacement of the waterproof seals.)
For distributors and repair stores that can replace the waterproof seals, please refer to our
website.
Other cautions
The accessories included with this product (such as the rechargeable battery) are not waterproof.
Subjecting the camera to shocks may break down water resistance.
The camera is not subject to waterproof with the battery/card compartment cover or connector
cover opened.
233
Using the camera underwater
1
2
To Next Page
Loading...
Need help?
General
