Press the OK button, then highlight Image stabilizer using
FG.
7
0.0
0
P
S-IS
ON
S-IS
ON
ACC
OFF
ACC
OFF
OFFOFF
Adjusting flash output (Flash intensity control)
Flash output can be adjusted if you find that your subject appears overexposed, or that it appears
underexposed even though the exposure in the rest of the frame is just right.
Highlight an option using HI and press the OK button.
Flash brightness can be reduced by selecting negative values (the lower the value, the
dimmer the flash) or increased by selecting positive values (the higher the value, the brighter
the flash).
Not available in 0 mode, when [i Underwater HDR] is selected in 6 mode, or in SCN
mode.
85
Adjusting flash output (Flash intensity control)
1.
2.
C