Omron 3G3JX - Page 259

Index
Index-2
M
main unit monitor display selection .......................... 4-40
maximum frequency .................................................. 4-8
momentary power interruption non-stop function .... 4-33
momentary power interruption retry ......................... 4-27
momentary power interruption/undervoltage trip during
stop selection ........................................................... 4-28
multi-function input .................................................. 4-43
multi-function input monitor ....................................... 4-2
multi-function output ................................................ 4-71
multi-function output monitor ..................................... 4-2
multi-function output selection ................................. 4-62
multi-step speed operation function ......................... 4-47
N
NDc .......................................................................... 4-68
O
OD ........................................................................... 4-65
OL ............................................................................ 4-65
OPE ......................................................................... 4-60
output current monitor ............................................... 4-1
output frequency monitor ........................................... 4-1
output frequency setting ............................................ 4-5
output terminal NC/NO selection ............................. 4-71
output voltage gain .................................................. 4-14
output voltage monitor ............................................... 4-3
overcurrent suppression .......................................... 4-42
overload limit/overload warning ............................... 4-31
overload warning ............................................ 4-32, 4-65
overvoltage LAD stop function ................................. 4-41
P
PID .................................................................. 4-20, 4-59
PID feedback value monitor ...................................... 4-1
PIDC ........................................................................ 4-59
power ON time ........................................................... 4-3
power recovery restart prevention ........................... 4-55
PTC ......................................................................... 4-57
R
RDY ................................................................ 4-42, 4-62
RDY (ready) function ............................................... 4-42
reduced torque characteristics (VP) ........................ 4-13
relay output contact selection .................................. 4-72
reset ......................................................................... 4-56
retry selection .......................................................... 4-27
rotation (digital operator) direction selection .............. 4-6
rotation (RUN) direction monitor ................................ 4-1
RS ............................................................................ 4-56
RUN ......................................................................... 4-63
RUN command selection ........................................... 4-7
S
SET .......................................................................... 4-51
SFT .......................................................................... 4-55
signal during RUN ................................................... 4-63
sink/source logic ...................................................... 2-11
soft lock ..........................................................4-33, 4-55
SP-SET .................................................................... 4-51
STA .......................................................................... 4-58
stabilization parameter ............................................ 4-76
start frequency ......................................................... 4-10
starting frequency .................................................... 4-36
STOP key selection ................................................. 4-39
stop selection ........................................................... 4-39
STP .......................................................................... 4-58
T
thermistor trip function ............................................. 4-57
torque boost ............................................................. 4-12
total RUN time ........................................................... 4-3
U
UDC ......................................................................... 4-59
UP ............................................................................ 4-59
UP/DOWN ............................................................... 4-59
USP ......................................................................... 4-55