Omron ACCURAX G5 - Control Output Details

3-41
3-1 Driver Specifications
Accurax G5 AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
3
Specifications
Control Output Details
Control Output Sequence
*1. In this section, the hardware inputs the servo ON signal, but the signal is not accepted.
*2. The servo ready completed output turns ON the moment the conditions of MPU initialization completed and main
circuit power supply establishment are both satisfied.
*3. Operation of the protective function starts approx. 1.5 seconds after the start of MPU initialization following an
establishment of internal control power supply. Make sure all I/O signals which connect to the amplifier (especially
forward/reverse direction, drive prohibition input and external scale input) are established before operation of the
protective function starts. Also, you can increase this time with Pn618 "Power Supply ON Initialization Time."
Control power supply
(L1C and L2C)
Internal control
power supply
MPU initialization
completed
Main circuit power
supply
(L1, L2 and L3)
Servo ready
completed output
(READY)
Alarm output
(ALM)
Positioning
completion output
(INP)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Approx. 100 to 300 ms
Approx. 2 s
Approx. 1.5 s
Iinitialization
*3
1 to 6 ms
Approx. 10 ms after initialization and main circuit ON
*2
Operation
command input
(RUN)
Dynamic brake
Motor power supply
Brake interlock
output (BKIR)
Servo position, speed,
torque input
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Approx. 60 ms
Approx. 2 ms
Approx. 4 ms
0 ms or more
0 s or more
100 ms or more
*1
Pn437