Omron ACCURAX G5 - Sequence I;O Signal; Input Signals; Outline of Operation

6
6-37
6-10 Sequence I/O Signal
Accurax G5 AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Applied Functions
6-10 Sequence I/O Signal
Outline of Operation
 You can set a sequence in various operating conditions.
 For the connection of I/O signals and processing of external signals, refer to "Control I/O
Connector Specifications (CN1)" (P.3-14).
Input Signals
You can allocate any function of input signals to the input pins for the control I/O connector
(CN1). In addition, you can change logics. However, refer to "Input Signal Allocation Method"
(P.6-38) for more information because some signals have allocation limitations.
If the G Series is being replaced, set the unit to the default setting before using it.
Input Signal Default Setting
The allocation of the default input signals is as follows. Refer to "Input Signal Allocation
Method" when you change the allocation to use.
Contacts NO and NC in the logic fields indicate the following statuses.
Applicable
parameters
Input
signals
Default set
value
Default setting state
Position control or
full closing control
Speed control Torque control
Signal
name
Logic
Signal
name
Logic
Signal
name
Logic
Pn400 SI1 input
00828282h
(8553090)
NOT
NC NOT NC NOT NC
Pn401 SI2 input
00818181h
(8487297)
POT
NC POT NC POT NC
Pn402 SI3 input
0091910Ah
(9539850)
DFSEL1 NO VZERO NC VZERO NC
Pn403 SI4 input
00060606h
(394758)
GSEL NO GSEL NO GSEL NO
Pn404 SI5 input
0000100Ch
(4108)
GESEL1
NO VSEL3 NO −−
Pn405 SI6 input
00030303h
(1979379)
RUN
NO RUN NO RUN NO
Pn406 SI7 input
00000f07h
(3847)
ECRST NO VSEL2 NO −−
Pn407 SI8 input
00040404h
(263172)
RESET
NO RESET NO RESET NO
Pn408 SI9 input
00050505h
(328965)
TVSEL NO TVSEL NO TVSEL NO
Pn409 SI10 input
00000E88h
(3720)
IPG NC VSEL1 NO −−