Omron CPM1 Programming Manual

153
Operation without a Battery Section 3-6
Note If the setting shown below is made in the PC Setup (DM 6655 bits 12 to 15),
battery errors (a non-fatal error) will not be detected even if the internal bat-
tery expires.
First Cycle Flag
25315
(Turns ON for 1 cycle at the start of operation.)
ANDW(34)
#67FF
252
252
DM 6655
15 12
Low Battery Error Enable
0 Hex: Detected
1 Hex: Not detected
11 08 07 04 03 00

Omron CPM1 Specifications

General

Model	CPM1
Manufacturer	Omron
Instruction Set	Basic and advanced instructions
Power Supply	100 to 240 VAC or 24 VDC
Communication	RS-232C
I/O Points	10, 20, 30, or 40 points depending on the model
Timers	Yes, multiple timers available
Counters	Yes, multiple counters available
Input Voltage	24V DC
Output Type	Relay or transistor
Number of I/O Points	10, 20, 30, 40
Communication Ports	RS-232C (optional)
Operating Temperature	0°C to 55°C
Storage Temperature	-20°C
Humidity	10% to 90% (non-condensing)
Dimensions	Varies depending on the model
Weight	Varies depending on the model
Program Memory	2048 steps (2K steps)