Omron G9SP-N20S - 8-2 Downloading Configuration Data to the G9 SP-series Controller and Verification

107
Functionality for All Option Board's Section 7-1
Transmission Data (G9SP-series Controller to Standard PLC)
The format of the data component sent to the PLC from the G9SP-series
Controller is shown below.
Optional Communications Transmission Data
These 32 bits of data can be used in the program of the G9SP-series Control-
ler. The data is displayed as Optional Communication Transmission Data in
the I/O Tag List.
Safety Input Terminal Data Flags
The flags show the ON/OFF values after self-diagnosis for the Safety Input
terminals.
0: Input terminal OFF or error.1: Input terminal ON.
+0 Optional Communications Transmission Data 4 bytes
+4 Safety Input Terminal Data Flags 6 bytes
+10 Safety Output Terminal Data Flags 4 bytes
+14 Safety Input Terminal Status Flags 6 bytes
+20 Safety Output Terminal Status Flags 4 bytes
+24 Safety Input Terminal Error Causes 24 bytes
+48 Safety Output Terminal Error Causes 16 bytes
+64 Reserved 2 bytes
+66 Unit Status 2 bytes
+68 Configuration ID 2 bytes
+70 Unit Conduction Time 4 bytes
+74 Reserved 20 bytes
+94 Present Error Information 12 bytes
+106 Error Log Count 1 byte
+107 Operation Log Count 1 byte
+108 Error Log 40 bytes
+148 Operation Log 40 bytes
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
+0 Bit 07 Bit 06 Bit 05 Bit 04 Bit 03 Bit 02 Bit 01 Bit 00
+1 Bit 15 Bit 14 Bit 13 Bit 12 Bit 11 Bit 10 Bit 09 Bit 08
+2 Bit 23 Bit 22 Bit 21 Bit 20 Bit 19 Bit 18 Bit 17 Bit 16
+3 Bit 31 Bit 30 Bit 29 Bit 28 Bit 27 Bit 26 Bit 25 Bit 24
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
+0 Si 07 Si 06 Si 05 Si 04 Si 03 Si 02 Si 01 Si 00
+1 Si 15 Si 14 Si 13 Si 12 Si 11 Si 10 Si 09 Si 08
+2 Reserved Si 19 Si 18 Si 17 Si 16
+3 Reserved
+4 Reserved
+5 Reserved